|
Time
|
Descriptions
|
Studiers
|
SRStatus
|
|
|
Monday, 11/1/04
|
|
|
|
0800-0805
|
Record XBPM data for user orbit with TopUp running
|
OPS
|
Stored Beam
|
|
0805-1100
|
To determine errors in RF5's klystron forward readback.
|
Cherbak
|
No Inj
|
|
0805-0900
|
Replace noisy fan assembly in IOCS25FB VME chassis.
|
Gold
|
No Beam
|
|
0805-1100
|
Test the SR Dipole Vesda interface to the Gespac.
|
Hillman Varotto
|
No Beam
|
|
0805-1200
|
Look into a faulty status/relay board on L1RG2 LFA TRIM.
|
Puttkammer
|
No Inj
|
|
0830-1230
|
Inject signals into L2 BPM cables to verify position accuracy.
|
Erwin
|
Access Linac
|
|
0830-1030
|
The strobe lamp, replaced on 10/18/04, is not flashing (see RMD#04328). The output module along with the associated fuse will be will be checked. If both are found to be working, the strobe base unit will be replaced with the same type.
|
Hogrefe
|
Access Linac
|
|
0830-1230
|
Modify EPICS database in LINAC ioclic1 and reboot ioclic1. Next, perform tests on RF Switching Control in the LINAC to confirm correct implementation of this database by switching through all five operation modes.
|
Quock
|
No Inj
|
|
0830-1030
|
Connect and test PAR gated camera and streak camera timing signal from injection system, possibly interrupt inj. timing briefly.
|
Yang, Lenkszus
|
No Inj
|
|
0830-1030
|
PAR bunch cleaning setup, beam is not required.
|
Grelick, Yao
|
No Inj
|
|
0830-1230
|
swap the L2 Trigger/ Interlock module as part of the ongoing L2 investigation.
|
Grelick
|
No Inj
|
|
0830-1030
|
Diagnose and repair Sector 18 horizontal corrector magnet S18B:H1 thermal switch ground fault.
|
Putnam, Puttkammer
|
Access
Zone C
|
|
0900-1030
|
Dosimeter replacement S3-4
|
Petra
|
Access
Zone A
|
|
0900-1100
|
Run full BPM system test from tunnel for 3BP5(x has -3mm raw), 3BP4 (x&y had 100 micron shift in both planes), 3BP2 (had 200 micron drift)
|
Erwin
|
Access
Zone A
|
|
0900-1100
|
SRPS script testing zones E
|
Fors
|
No Beam
|
|
0900-1100
|
Replace DAC Cards for Canted Undulator Dipoles
|
Puttkamer
|
No Beam
|
|
0900-1000
|
Add new PVs for RFGUN phase detector prototype testing PVs to IOCLIBPM2.
|
Norum, Erwin
|
|
|
1030-1130
|
Reset xbpm limit for 16IDP2X(-)
|
Hahne
|
Access
Zone B
|
|
1130-1230
|
Set-up to measure SR Gap Voltage noise
|
Horan/Trento
|
No Beam
|
|
1230-1300
|
Recover equipment & refill the Ring
|
OPS
|
Stored Beam & Injection
|
|
1300-1500
|
Measure SR Gap Voltage noise
|
Horan/Trento
|
Stored Beam
|
|
1300-1400
|
Test new Linac P.S. conditioning status records
|
Borland
|
Lim. Inj.
|
|
1500-1800
|
ID2/3/14/17 xbpm & id26 P0 nbbpm tests
|
Singh/Hahne
|
Stored Beam
|
|
1800-2000
|
Booster Automatic Ramp correction (parasitic)
|
Sereno
|
Top-up
|
|
1800-2000
|
Collect ID feedforward data
|
Decker/Singh
|
Stored Beam & Top-Up
|
|
2000-2200
|
Recheck Coupling correction of CPU
|
Emery
|
Stored Beam
|
|
2300-2400
|
Injection Transient Characterization
|
Emery
|
Stored Beam & Inj.
|
|
|
Tuesday, 11/2/04
|
|
|
|
0000-0100
|
Injection transient characterization
|
Emery
|
Stored Beam & Inj.
|
|
0100-0500
|
Injection efficency investigation
|
Emery/Sajaev
|
Stored Beam & Inj.
|
|
0500-0700
|
Operator training-SR 2300-0700
|
Forth
|
Stored Beam & Injection
|
|
0700-1300
|
HOM Studies
|
Nassiri/Harkay
|
Stored Beam & Inj.
|
|
0700-1100
|
Linac Phase Detector Studies (parasitic)
|
Sereno/Pasky/Lill/Erwin
|
Injection Possible
|
|
1100-1300
|
Operator training-Booster 0800-1500
|
Glenn/ Grodecki
|
Limited Inj
|
|
1100-1500
|
PAR instability study (parasitic)
|
Chae/Yang/Yao
|
Injection Possible
|
|
1300-1500
|
Lifetime measurements with sextupoles set to zero
|
Borland
|
Stored Beam & Inj
|
|
Contact MCR to schedule
|
Investigate loss of communication to storage ring sector 40 vacuum valve PV VM:40:2IP5. Check communication link from multiple pump controller (MPC) to bitbus bug.
|
Quock
|
No Impact
|
|
1500-1900
|
Par Bunch Cleaning Study
|
Sereno/Yao
|
Stored Beam & Inj.
|
|
1900-2400
|
Orbit Stability Baseline Measurement
|
Decker
|
Stored Beam & Top-up
|
|
1900-2300
|
Test Run of bunch cleaning with Top-Up
|
Yao/Ops
|
Stored Beam & Top-up
|
|
|
Wednesday, 11/3/04
|
|
|
|
2400-0100
|
Orbit Stability Baseline Measurement
|
Decker
|
Stored Beam & Top-Up
|
|
0100-0200
|
Measure bpm gains in hybrid mode
|
OPS/Sajaev
|
Stored beam
|
|
0200-0400
|
PAR Training
|
Gagliano
|
Lim. Inj.
|
|
0400-0500
|
SR Training
|
Forth
|
Stored beam & Inj.
|
|
0400-0700
|
Optimize bunch purity (not using SR for 1st hour)
|
Sereno
|
Stored beam & inj.
|
|
0700-0800
|
Ready for 0+24X1 fill pattern, low emittance, TopUp
|
OPS
|
Stored Beam & Injection
|